ChatterBack🔍Join
States/California/MeshCore/ALC_HM
MC

ALC_HMRepeaterObserver

e40313186611 · openHop-Repeater · California
● Heard 4 h agovia corescope.bayareameshcore.org
Position as last reported by the node. Members’ own nodes can be shown at grid precision instead.

How this repeater scores

CoreScope · relative to this mesh
D
0.28 / 1.00
D is 0.15 and above. 0.30 would make it C.
1181
relayed · 24 h
  • Bridgeweight 0.300.07 × 0.30 = 0.020

    How much of the mesh has to pass through it. A chokepoint between two halves of a network scores high. Traffic has other ways round. Not a fault - it means the area is well connected.

  • Coverageweight 0.250.68 × 0.25 = 0.171

    How much of the mesh it can reach, weighted so near neighbours count more than distant ones.

  • Redundancyweight 0.250.29 × 0.25 = 0.072

    What breaks if it vanishes. High means nothing else covers its job.

  • Trafficweight 0.200.08 × 0.20 = 0.016

    How much it actually relayed, measured rather than inferred from the map. It is carrying little traffic compared with the busiest repeater here.

What would actually change this

A low grade on a repeater that works fine usually means the area is well served, not that the machine is bad. Over half the weight — Bridge and Redundancy — describes where it sits among its neighbours, and neither is yours to move.

  • This one is well sited

    It out-reaches 78 of the 97 repeaters within 25 miles, which average 0.47. If the grade is still low, that is about position in the network rather than anything the radio is doing wrong.

  • A low Bridge is not a fault

    Bridge measures how much traffic has no choice but to pass through this node. It falls when neighbours put up repeaters that cover the same ground — so it can drop without anything changing here at all. There is nothing to tune.

  • Reachable, but not on anyone's path

    It can hear plenty and is relaying little, which usually means traffic has shorter routes. That follows from where the people are, and tends to change on its own as the mesh grows.

Every axis is scored against the other repeaters this analyzer can see, so 1.00 means “the best of these” rather than perfect, and a grade here is not comparable with one from another mesh. CoreScope’s own note on the bands is that they are a first cut, not tuned against real data — so treat the letter as a rough impression and the number as the real answer.

History

47 samples · last 30 days
Neighbours4227–42

Node

from the mesh, refreshed every few hours
Protocol
MeshCore
Node ID
e40313186611
Role
Repeater
Hardware
openHop-Repeater
Preset
-
Channel
-
Firmware
1.1.5.dev159
Neighbors
42
Relayed 24 h
1181
Adverts seen
31
Coverage
0.68
Usefulness
D · 0.28
First seen
2026-08-01